Top Fencing Companies in Martinsville, IL, 62442 | Compare & Call

First, contact JULIE (Joint Utility Locating Information for Excavators) at least three business days before excavation. Hitting a gas or fiber line in Central Martinsville is a major financial and safety liability. Second, verify with the Martinsville permit office that your project meets all codes. We manage this paperwork to ensure compliance from the start.

Martinsville zoning enforces a 3-foot height limit in front yards and a 6-foot limit in rear yards. A 0-foot setback allows installation directly on the property line. For corner lots, especially near I-70, you must maintain a clear 'sight triangle' at intersections—typically a 10-foot area from the curb where vegetation and fences over 3 feet are prohibited for driver visibility.

After a site consultation. Our standard route from Martinsville City Park via I-70 allows for a 15-20 minute response to most Central Martinsville addresses. Following the JULIE locate and permit approval, mobilization typically occurs within 5-7 business days, weather and material delivery permitting.

Yes, for any shared boundary. Illinois Compiled Statutes 765 ILCS 130/1 (the Boundary Fence Act) governs partition fences. A 2026 legal best practice is providing written notice to adjoining landowners before replacing or installing a shared fence. This establishes good faith and can prevent disputes over cost-sharing.

The 32-inch frost line depth is a structural mandate. Footings must extend below this depth to prevent frost heave, which lifts posts and destroys fence integrity. In Central Martinsville's silty clay, IRC Section R403 mandates this depth for stability. Posts set shallower will fail within two winters.

Martinsville's 105 MPH V-ult wind speed rating governs the design. This ultimate wind speed, per ASCE 7-22 standards, dictates post spacing, concrete footing mass, and bracket strength. A fence built to this rating will survive peak storm season gusts, especially in open areas exposed to winds off I-70. Lighter designs will likely fail.

Gates must meet IBC/IRC pool safety codes: self-closing, self-latching hardware with the latch placed at 54 inches minimum height above grade. While smart-gate IoT integration is a low trend here, any electronic latch system must have a mechanical failsafe to meet these standards and limit homeowner liability.

Moderate termite risk and low-to-moderate soil corrosivity dictate material compatibility. Pressure-treated pine or cedar must be rated for ground contact. For metal posts, use hot-dip galvanized steel. Aluminum or vinyl are inert options. Always specify stainless steel or polymer-coated fasteners to prevent rust streaks from corroding nails.